Get One Month of Starlink FreeSPECIAL OFFER: GET A FREE MONTH OF STARLINK >
Close-up of a yellow Ethernet cable with connectors on a blue background.

Wire Deco Satellites on Starlink Without Creating a Network Loop

Equipment & Accessories

Back to Equipment & Accessories

Ethernet backhaul can remove a weak wireless hop between Deco units. The important detail is where those cables connect: Router mode and Access Point mode do not use the same wiring rules.

Work through the setup

Step 1

Write down the current Deco operating mode. Photograph the main unit's WAN and LAN connections before adding another cable.

Step 2

Pair and update the Deco units using the manufacturer's setup process before introducing the wired backhaul.

Step 3

In Router mode, keep satellite links downstream of the main Deco's LAN. Do not bypass the main Deco through an upstream switch.

Step 4

In Access Point mode, use TP-Link's permitted topology for the existing router. Avoid connecting the same switch path twice.

Step 5

Add one cable at a time and check the app's backhaul indication. Disconnect the last added link if the whole network becomes unstable.

Step 6

Test a wired and wireless client at each end. Save the final wiring diagram near the network equipment for future troubleshooting.

Worked example

Suppose two satellites each connect to a switch that sits before the main Deco while Deco is routing. The tidy-looking cabling can bypass the intended downstream path. Redraw the network with the main Deco's WAN and LAN marked explicitly, then compare the manufacturer's Router-mode diagram. Reconnect the satellites one at a time on the correct side and verify the app's backhaul report before treating the job as complete.

Interpret the result

  • Instability begins with one cable: Remove that link and inspect its topology.
  • Only one satellite reports wired: Check the other cable and port path.
  • All units are stable: Save the exact wiring diagram.

Checks and limitations

A successful internet test at the main unit does not prove every satellite has wired backhaul. Verify each cable's path and the reported connection type; any uncabled satellite may still use Wi-Fi.

Where should a wired Deco satellite connect when Deco is in Router mode?

Connect it to the main Deco's LAN side, directly or through a switch downstream of that LAN. TP-Link's Router-mode topology differs from Access Point mode. Check the diagram for your mode before connecting satellites through an upstream switch.

Sources and review

Official documentation for this guide

Reviewed: 11 November 2026. The practical sequence and worked example are Starlink Tips editorial guidance. Check current instructions for your hardware, software and country.

Illustrative photograph: Close-up of a yellow Ethernet cable with connectors on a blue background. Credit: Ann Hannes.