Get One Month of Starlink FreeSPECIAL OFFER: GET A FREE MONTH OF STARLINK >
Close-up of dual computer monitors with green coding interfaces in a dark room, highlighting cyber security themes.

Test Guest Isolation on Starlink for Both IPv4 and IPv6

Tips & Tricks

Back to Tips & Tricks

A guest network should be tested against the private resources it is meant to protect. Checking one IPv4 address alone can miss another path.

Work through the setup

Step 1

Write down the private devices guests must not reach, including router administration, storage and cameras.

Step 2

Use a separate guest device that has no saved private Wi-Fi credentials. Confirm it actually joins the guest network.

Step 3

Check internet access first, then attempt authorised tests to the listed private services using their normal names and addresses.

Step 4

If IPv6 is enabled, include the applicable IPv6 paths in the firewall review. Use the vendor's rules for your installed version.

Step 5

Test guest-to-guest access against the policy too. A guest VLAN and client isolation address different boundaries.

Step 6

Record allowed and denied results and remove temporary test permissions. Repeat after significant gateway or Wi-Fi changes.

Worked example

Suppose an owner checks that guests cannot open a NAS by its IPv4 address and considers the job complete. The same service may have another reachable address or a discoverable name. Review the actual protocol paths used by the service and test the intended isolation from a genuine guest device. Preserve the test results for later firmware changes.

Interpret the result

  • Private service is reachable: Correct the relevant rules before offering guest access.
  • Internet works and private services fail as intended: Record the isolation test.
  • Only one address family was tested: Complete the other applicable paths.

Checks and limitations

Do not assume that hiding a network name or enabling a VLAN proves isolation. Review the actual service paths. If you cannot confidently assess IPv6 rules, ask a competent administrator rather than opening broad exceptions.

Sources and review

Official documentation for this guide

Reviewed: 11 November 2026. The practical sequence and worked example are Starlink Tips editorial guidance. Check current instructions for your hardware, software and country.

Illustrative photograph: Close-up of dual computer monitors with green coding interfaces in a dark room, highlighting cyber security themes. Credit: Tima Miroshnichenko.